Summary-Prefix; Timers Basic - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
48 Confidential and Proprietary Information of ZTE CORPORATION
show ipv6 rip interface [<interface-name>]
<interface-name>
This command is disabled by default.
This command is used to display information about the interface
on which RIPng is enabled.
This example describes how to display the interface information.
ZXR10#show ipv6 rip interface fei_3/1
fei_1/3: RIPng is enabled
IPv6 interface address:
5657::57:57/16
1::31/64
5657::57/16
fei_1/8: RIPng is enabled
IPv6 interface address:
2007:6:5::/64

summary-prefix

Use this command to configure the summary route, and use the
no form of this command to delete the aggregation configuration.
Router configuration
summary-prefix X:X::X:X/<0-128>
no summary-prefix X:X::X:X/<0-128>
X:X::X:X/<0-128>
This command is disabled by default.
To summarize the IPv6 route, use this command.
This example describes how to configure a summary route.
ZXR10(config)#ipv6 router rip
ZXR10(config-router)#summary-prefix 100::/64

timers basic

Use this command to configure the RIPng timer. Use the no form
of this command to delete the configured timer and restore the
default value.
Router configuration
timers basic <update><timeout><garbage>
no timers basic
Specific interface name
IPv6 route prefix and length of the
summary route