Bgp Router-Id; Bgp Update-Delay - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Defaults
Syntax
Description
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Syntax
Description
92 Confidential and Proprietary Information of ZTE CORPORATION
no bgp graceful-restart [stale-time <seconds>][restart-time
<seconds>]
The behavior of this command is disabled by default.
stale-time
<seconds>
restart-time
<seconds>
This example describes how to configure BGP to activate graceful
restart capability.
ZXR10(config)#router bgp 1
ZXR10(config-router)#bgp graceful-restart

bgp router-id

Use this command to manually configure the BGP router identifier.
Cancel this function with the no form of this command.
Router configuration
bgp router-id <ip-addr>
<ip-addr>
The router identifier is not configured by default.
Use this command to manually configure the BGP router identifier.
This example describes how to set the BGP router identifier as
1.2.1.3.
ZXR10(config)#router bgp 1
ZXR10(config-router)#bgp router-id 1.2.1.3

bgp update-delay

Use this command to set the maximum initial delay. Restore the
initial delay to its default value with no form of this command.
Router configuration
bgp update-delay <seconds>
no bgp update-delay <seconds>
This command is disabled by default.
<seconds>
Time of the stale timer in seconds, range:
1~3600, default: 360 seconds
Time of the restart timer in seconds, range:
1~3600, default: 120 seconds
Router identifier, in dotted decimal format
Update delay in seconds, range: 1~3600,
default: 120 seconds