Set-Overload-Bit; Show Isis Database - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
80 Confidential and Proprietary Information of ZTE CORPORATION
This command is disabled by default.
This example describes how to configure the router leak from
level-2 to level-1.
ZXR10(config)#router isis
ZXR10(config-router)#address-family ipv6
ZXR10(config-router-af)#route-leak level-2 into level-1 metric
66 route-map 66

set-overload-bit

Use this command to configure the router to signal other routers
not to use it as an intermediate hop by setting the overload bit
of the LSP packets transmit by itself. Delete the flag with the no
form of this command.
Router configuration
set-overload-bit [suppress {external [interlevel]| interlevel
[external]}| on-startup <5~86400>[suppress {external [int
erlevel]| interlevel [external]}]]
no set-overload-bit
suppress {external
| interlevel}
on-startup
<5-86400>
The overload bit is not set by default.
This command is supported after platform version 4.6.02.
This example describes how to set the overload bit of the LSP pack-
ets transmit by itself and then delete the flag.
ZXR10(config)# router isis
ZXR10(comfit-router)# set-overload-bit
ZXR10(comfit-router)# no set-overload-bit

show isis database

Use this command to display the IS-ISv6 database.
All modes
show ipv6 isis database [[detail | verbose [l1 | l2 | level-1 |
level-2]]|[level-1 | level-2 | l1 | l2 [detail | verbose]]]
Causes the type of prefix identified by the
subsequent keyword to be suppressed.
External: Prevents the IP prefixes learned
from another IS-IS level from being
advertised.
Internal: Prevents the IP prefixes learned
from other protocol from being advertised.
Causes the overload bit to be set upon system
startup and remain set for the specified
number of seconds. The range is 5 to 86400
seconds.