Ipv6 Mld Static-Group; Ipv6 Multicast-Routing - Zte ZXR10 Command Manual

Syntax
Description
Instructions
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Related
Commands
Purpose
Command Modes
Syntax
Defaults
Instructions
<interval>
This command does not take effect until the proxy querier is con-
figured.
ipv6 mld snooping querier
ipv6 mld snooping query-interval

ipv6 mld static-group

Use this command to configure the static group member on IGMP
interface. Delete the static group member on IGMP interface with
the no form of this command.
Interface configuration
ipv6 mld static-group <group-address>
no ipv6 mld static-group {<group-address>| all }
<group-address>
all
When interfaces of mld static group members are configured,
members of this group is supposed to appear on the interface for
ever.
show ipv6 mld groups

ipv6 multicast-routing

Use this command to enable IPv6 multicast routing function. Dis-
able this function with the no form of this command.
Global configuration

ipv6 multicast-routing

no ipv6 multicast-routing
IPv6 multicast routing function is disabled by default.
After disabling IPv6 multicast routing selection function, the router
will not forward any multicast packet and stop running multicast
routing protocol at the same time.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 IPv6 Multicast Protocol
Mmaximum query-response-interval, in
seconds, range: 1~255, default: 10 seconds
Group address added into static mls in
X:X::X:X format
The no command with the parameter all
deletes all the static groups
137