ZXR10 Command Manual (IPv6 Volume)
Related
Commands
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
14
Confidential and Proprietary Information of ZTE CORPORATION
ipv6 route
ipv6 nat enable
Use this command to enable the Network Address Translation-Pro-
tocol Translation. Disable it with the no form of this command.
Global configuration
ipv6 nat enable
no ipv6 nat enable
Network Address Translation-Protocol Translation is disabled by
default.
This command is provided after the platform version 4.6.02.
This example describes how to enable the Network Address Trans-
lation-Protocol Translation.
ZXR10(config)#ipv6 nat enable
ipv6 nat prefix
Use this command to set Network Address Translation-Protocol
Translation for IPv6 packets of the specified prefix.
Global configuration
ipv6 nat prefix <ipv6-prefix>|<prefix-length>
no ipv6 nat prefix
<ipv6-prefix>
<prefix-length>
IPv6 network prefix is not set by default.
This command is supported after the platform version 4.6.02.
If the prefix of the destination address of the received IPv6 packet
is the set prefix, the IPv6 packet will be converted to an IPv4
packet with Network Address Translation-Protocol Translation.
This example describes how to set the prefix of the destination
address as 2004::/96.
ZXR10(config)#ipv6 nat prefix 2004::/96
Network prefix
Length of the prefix, 96 only