Ipv6 Nd Ra-Interval; Ipv6 Nd Ra-Lifetime - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
22 Confidential and Proprietary Information of ZTE CORPORATION
is not set, and hosts on the link cannot use the prefix as IPv6
address auto-configuration.
ZXR10(config-if)# ipv6 nd prefix 400::/64
no-autoconfig
show ipv6 interface
debug ipv6 nd
ipv6 nd suppress-ra

ipv6 nd ra-interval

Use this command to configure the interval between IPv6 router
advertisement (RA) transmissions on an interface. Restore the
default interval with the no form of this command.
Interface configuration
ipv6 nd ra-interval <seconds>
no ipv6 nd ra-interval
<seconds>
This command is supported after the platform version 4.6.02.
Interval between IPv6 RA transmissions uses the configured value
on the interface. However, at the first stage when router adver-
tisements transmissions are enabled on the interface, the interval
is 16 seconds no matter how much the configured interval between
router advertisements transmissions is.
This example describes how to set the interval between IPv6 RA
transmissions as 200 seconds.
ZXR10(config-if)# ipv6 nd ra-interval 200
show ipv6 interface
debug ipv6 nd
ipv6 nd suppress-ra

ipv6 nd ra-lifetime

Use this command to configure the "router lifetime" value in IPv6
router advertisements on an interface. Restore the default lifetime
with the no form of this command.
Interface configuration
ipv6 nd ra-lifetime <seconds>
no ipv6 nd ra-lifetime
100 200 off-link
Interval between IPv6 RA transmissions in
seconds, range: 3 ~ 1800, default: 600