2. Insert the optical drive into chassis opening and push all the way until it stops (see letter B).
Connect the cables as shown (see letter C).
Removing a Slimline Optical Drive
1. Remove the cables (see letter A). Slide the optical drive out (see letter B and C).
2. If no device will be installed in this location, install a filler panel in this location.
Installing and Removing the Intel
Before installing or removing the Intel
performed.
1. Ensure the AC power cord(s) are disconnected from the system.
2. Remove the system cover. For instructions, see
®
Intel
Server System R2000LH2/LT2 Service Guide
Figure 58. Installing an Optical Drive
Figure 59. Removing the Slimline Optical Drive
®
I/O expansion module, please make sure following steps are
Hardware Installations and Upgrades
®
I/O Expansion Module
Removing the System
Cover.
37