Installing Or Removing A Slimline Optical Drive; Installing A Slimline Optical Drive (Sr1530Cl) - Intel SR1530CL User Manual

7. With the black lever in the fully open position, slide the drive carrier into the server
system. The green latch must be to the right. Do not push on the black lever until
the lever begins to close by itself.
Note: For proper airflow, the hard drive carrier must be replaced in the server
8. When the black lever begins to close by itself, push on it to lock the drive carrier
into place.
9. Install the server system cover. For instructions, see
Cover" on page
10. (Optional) Install the front bezel. For instructions, see
on page
11. Plug all peripheral devices and the AC power cable(s) into the server.

Installing or Removing a Slimline Optical Drive

Caution: The optical drive is NOT hot swappable. Before removing or replacing the optical drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
Note: Slimline optical drive installations and removal instructions differ between the Intel®
Server System SR1530HCL and Intel® Server System SR1530HCL / SR1530HCLS. Be
sure to follow the instructions that correspond to your server system.

Installing a Slimline Optical Drive (SR1530CL)

Note: If you are replacing an optical drive, see
(SR1530CL)" on page 56
Note: The hardware necessary to install your optical drive was shipped to you in a bag labeled
"CD-ROM Assy".
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Remove the bezel if it is installed. For instructions, see
Bezel" on page
®
Intel Server System SR1530CL / SR1530HCL / SR1530HCLS
system even if no hard drive is installed in it.
29.
27.
for instructions first. Return to these steps when directed.
iii.
28.
26.
"Installing the Server System
"Installing the Front Bezel"
"Removing a Slimline Optical Drive
"Removing the Server
"Removing the Front
"Safety
49