Table of Contents
Advertisement
Installing or Removing a Slimline Optical Drive
Caution: The optical drive is NOT hot-swappable. Before removing or replacing the optical drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
Installing a Slimline Optical Drive
Notes:
•
If you are replacing an optical drive, see
page 48
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove two screws secured the Filler Panel.
4. Remove the Filler Panel.
Figure 27. Removing the Knock-out from the Sheet Metal Panel
5. Attach the latch to the optical drive as shown, using two screws.
48
for instructions first. Return to these steps when directed.
iii.
®
Intel
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide
"Installing a Slimline Optical Drive" on
A
B
AF003724
"Safety
Advertisement
Table of Contents
