turn off the system by pressing the power button, and unplug the power cord from the system or
wall outlet.
Note: To eliminate the possibility of installing the replacement connector on the wrong side of the
PCI riser assembly, replace one connector at a time.
Removing a PCI Riser Card
1. Disconnect any cables attached to any add-in cards.
2. Remove the PCI riser assembly. For instructions, see
3. Remove any add-in cards from the PCI riser card. For instructions, see
in
Card".
4. Remove the two screws securing the PCI Riser Card (see letter "A").
5. Remove from the riser card from riser assembly (see letter "B").
Installing a PCI Riser Card
1. Place the riser card onto the riser assembly (see letter "A").
2. Secure the riser card using the two screws (see letter "B").
Installing and Removing a Slimline Optical Drive
Caution: The slimline optical drive is NOT hot-swappable. Before removing or replacing the drive,
you must first take the server out of service, turn off all peripheral devices connected to the system,
turn off the system by pressing the power button, and unplug the power cord from the system or
wall outlet.
®
Intel
Server System R1000BB Service Guide
Figure 48. Removing the PCI Riser Card
Figure 49. Installing the PCI Riser Card
Hardware Installations and Upgrades
"Removing the PCI Riser
"Removing a PCI Add-
Assembly".
31