Hardware Installations and Upgrades
Removing a PCI Add-in Card
1. Remove the screw on the retention device, remove the retention device.
2. Remove the PCI add-in card from the PCI slot.
3. Install the filler panel back, insert the retention device and tighten the screw.
Note: Make sure that all empty add-in card slots have filler panels installed.
Installing and Removing a Slimline Optical Drive
Caution: The slimline optical drive is NOT hot-swappable. Before removing or replacing the drive,
you must first take the server out of service, turn off all peripheral devices connected to the system,
turn off the system by pressing the power button, and unplug the power cord from the system or
wall outlet.
To maintain proper system cooling, a filler panel must be installed if you do not install a device at
this location.
Installing a Slimline Optical Drive
1. Install the plastic guide onto the back of the drive and attach with two screws as shown (see
letter A).
2. Insert the optical drive into chassis opening and push all the way until it stops (see letter B).
Connect the cables as shown (see letter C).
30
Figure 44. Installing the Plastic Guide to the Optical Drive
Figure 45. Installing an Optical Drive
®
Intel
Server System R2000SC Service Guide