Replacing The Backplane; Removing The Backplane; Installing The Backplane; Figure 74. Removing The Backplane - Intel R2000LH2 Service Manual

Server system

Hide thumbs Also See for R2000LH2:

Table of Contents

Hardware Installations and Upgrades

Replacing the Backplane

Before removing or installing the backplane, please make sure following steps are performed.

1. Ensure the AC power cord(s) are disconnected from the system.

2. Remove the system cover. For instructions, see

3. Remove all hot-swap drive carriers, regardless of whether or not a drive is installed in the carrier.

1. Disconnect all cables from the backplane.

2. Remove the screw (see letter A).

3. Pull up the backplane (see letter B).

4. Remove the backplane from the server chassis (see letter C).

1. Hold the backplane only by the edges. Do not push or pull on any components on the backplane.

Position the backplane in place at the front of the server system (see letter A).

2. Slide the backplane into the server system guides (see letter B).

3. Secure the backplane with the screw as shown (see letter C).

4. Connect cables to backplane, please refer to

Removing the System

Cable

Cover.

Routing.

Intel

Server System R2000LH2/LT2 Service Guide

Table of Contents

R2000lt2