Loading Supply In The Cartridge - DataCard magna User Manual

2-8
Remove the supply cartridge
E
1
2
3
4

Loading supply in the cartridge

After removing the supply cartridge from the printer, remove the used material and
load new material.
Load supply in the cartridge
1
2
3
If the printer has a locking cover, unlock the cover before opening it.
Lift the top cover, as shown in
!
The module is HOT to the touch and remains HOT for up to 30 minutes after
the printer is powered off.
Lift the supply tracker, and then push until it clicks into place (step 1 in
Figure 2-10).
Figure 2-10: Remove the supply cartridge
Pull out on the cartridge lock to release the supply cartridge (step 2 in
Figure 2-10).
Pull the supply cartridge out until the cartridge is out of the printer (step 3 in
Figure 2-10).
Place the supply cartridge upside down on a level surface, such as a table, with
the wide side away from you.
Remove the spool caps (if used) from both spools.
Pull up firmly on the full take-up spool to remove it.
Figure 2-5.
Supply tracker
♦
User's Guide for Magna™ Platinum Series™ Printers
Using the printer
2
3