Laminate Material - DataCard magna User Manual

Ribbon Part
type number
K process 596230-005
†
blue
K green 596230-006
K scratch-off 548237-001
#.
This ribbon is larger than the printer capacity. Remove 7 yards (6.5 m) of ribbon before loading this roll
in the printer.
†.
For color printers, set ribbon type to K; do not use the Always Autodetect setting.
i
i

Laminate material

Use Datacard DuraGard® laminate material in the Magna printer if the printer includes
an optional overlay module. (Laminate is also called overlay.) If you use 1.0 mil or 1.1
mil laminate, you must also use composite (not PVC) cards because of the heat
required to apply 1.0 mil or 1.1 mil material.
i
The following describes the laminate materials you can use:
DuraGard
0.6 mil
Holographic
Laminate
DuraGard
0.6 mil
Smart Card
Holographic
Laminate
User's Guide for Magna™ Platinum Series™ Printers
Images
printed Panel description
1,800 Continuous process (light)
blue
1,800 Continuous green
800 Continuous scratch-off panel Scratch-off
If you change the type of ribbon you use, be sure to make the appropriate
changes to the printer driver. See "Changing the type of print ribbon" in the
e-Guide for ImageCard® Magna™ and UltraGrafix® Magna™ Printers.
When you use a monochrome-only print ribbon, use a printhead cartridge
designed for monochrome printing for optimum results. When you use a color
ribbon that includes a K (monochrome or black) panel, use a color printhead
cartridge. See "Printhead cartridge" on page
If the printer has an optional topcoat module, see
Name Part number
547562-001
547562-052
Colors
Blue
Green
B-14.
"Topcoat material" on page
Heater roller
Either Die-cut polyester patches on a
carrier material with a tamper-
evident image.
About 300 uses.
Either Die-cut polyester patches on a
carrier material with a tamper-
evident image. Patch covers all
of the card except the area of the
smart card chip.
About 300 uses.
B-3
One panel set
prints:
Not applicable
Not applicable
Not applicable
B-5.
Description