Switch Port Commands - D-Link DES-2108 User Manual

config ipif
Purpose
Syntax
Description
Parameters
Example usage:
To configure the IP interface System:
show ipif
Purpose
Syntax
Description
57
Used to configure the System IP interface.
config ipif [ipaddress <network address> |
{gw <ipaddress>} | dhcp {vid <vid 1~4094>}]
This command is used to configure the System
IP interface on the Switch.
ipaddress <network address> - IP address and
netmask of the IP interface to created. You can
specify the address and mask information using
traditional
192.168.100.100/255.255.255.0
format 192.168.100.100/24.
gw <network address> - Designates the
gateway IP address.
dhcp - Allows the selection of the DHCP protocol
for the assignment of an IP address to Switch's
system IP address.
<vid 1~4094> - Specific the 802.1Q VLAN ID to
the Switch. The range between 1 to 4094.
Figure 53. config ipif command
Used to display the configuration of an IP
interface on the Switch.
show ipif
This command will display the configuration of an
format
or in CIDR