Igmp Snooping Commands - D-Link DES-2108 User Manual

show snmp trap
Purpose
Syntax
Description
Parameters
Example usage:
To display the currently configured SNMP trap state on the Switch:

IGMP Snooping Commands

The IGMP Snooping commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following
table.
Command
config router_ports
enable igmp snooping
83
Used to display the recipient of SNMP traps
generated by the Switch's SNMP agent.
show snmp trap
This command is used to display the IP
addresses and configuration information of
remote SNMP managers that are designated as
recipients of SNMP traps that are generated by
the Switch's SNMP agent.
None.
Figure 84. show snmp trap command
Parameters
[add
<port_list>
| delete] vid <vid> port