802.1x Commands
The 802.1x commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
enable 802.1x
disable 802.1x
config radius
config 802.1x
show 802.1x
Each command is listed in detail below.
enable 802.1x
Purpose
Syntax
Description
Parameters
Example Usage:
110
Parameters
<IP> port <port> key <key>
[auth_configuration [enable_reauth
<enable | disable> | quiet_period
<secs 0-65535> | tx_period <secs
1-65535> | supp_timeout <secs 1-
65535> | server_timeout <secs 1-
65535> | max_req <secs 1-10> |
reauth_period <1>]
Port <port_list> <enable | disable>]
[auth_configuration | auth_state |
port <port_list>]
Used to enable 802.1x on the switch
enable 802.1x
This command allows you to enable 802.1x
None.