Parameters
Example usage:
To display IP interface settings:
Switch Port Commands
The switch port commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
config ports
show ports
Each command is listed, in detail, in the following sections.
58
IP interface of the Switch.
None.
Figure 54 show ipif command
Parameters
<portlist | all> [speed <disable |auto
|10_half | 10_full | 100_half |
100_full> | flow_control <enable |
disable> | qos <low | medium | high |
highest>]
{portlist}