Management VLAN Commands
The Management VLAN commands in the Command Line Interface
(CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config mgt_vlan
Each command is listed, in detail, in the following sections.
config mgt_vlan
Purpose
Syntax
Description
Parameters
Example usage:
To set the VLAN 2 as the management VLAN:
To disable the management VLAN:
115
Parameters
[enable <vid>|disable]
Used to configure the management VLAN
[enable <vid>|disable]
This command is used to enable or disable the
management VLAN of the switch.
<vid> - To specify which VLAN to be the
management VLAN.
Figure 122. config mgt_VLAN command