SNMP Commands
The SNMP commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
enable snmp
disable snmp
config
community
show snmp community
enable snmp traps
disable snmp traps
config snmp trap
show snmp trap
Each command is listed, in detail, in the following sections.
77
Figure 76. show stp ports command
[read_only|read_write] comm_name
snmp
<name 20>
trap_ip < ipaddress > trap_name
<name 20> trap_event <bootup |
t_link | t_rx_error | t_tx_error>