D-Link DES-2108 User Manual page 79

disable stp
Purpose
Syntax
Description
Parameters
Example usage:
To disable STP on the Switch:
config stp
Purpose
Syntax
Description
Parameters
Parameters
73
Used to disable STP on the Switch.
disable stp
This command allows the Spanning Tree
Protocol to be disabled on the Switch.
None.
Figure 72. disable stp command
Used to setup STP on the Switch.
[maxage <value 6-40> | hellotime <value 1-10>
| forwarddelay <value 4-30> | priority <value 1-
65535>]
This command is used to setup the Spanning
Tree Protocol (STP) for the entire Switch.
maxage <value 6-40> - The value may be set to
ensure that old information does not endlessly
circulate through redundant paths in the network,
preventing the effective propagation of the new
information. Set by the Root Bridge, this value
will aid in determining that the Switch has
spanning tree configuration values consistent
with other
devices on the bridged LAN. If the value ages out