Spanning Tree Commands - D-Link DES-2108 User Manual

Spanning Tree Commands

The spanning tree commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following
table.
Command
enable stp
disable stp
config stp
config stp ports
show stp
show stp ports
Each command is listed, in detail, in the following sections.
enable stp
Purpose
Syntax
Description
Parameters
Example usage:
To enable STP on the Switch:
72
Parameters
[maxage <value 6-40> | hellotime
<value 1-10> | forwarddelay <value
4-30> | priority <value 1-65535>]
[all | <portlist>] {cost <value 1-
65535> | priority <value 0-255>}
<portlist>
Used to enable STP on the Switch.
enable stp
This command allows the Spanning Tree
Protocol to be enabled on the Switch.
None.
Figure 71. enable stp command