D-Link DES-2108 User Manual page 80

Example usage:
To configure STP with maxage 40 and hellotime of 5 seconds:
74
and a BPDU has still not been received from the
Root Bridge, the Switch will sending its own
BPDU to all other switches for permission
become the Root Bridge. If it turns on that your
switch has the lowest Bridge identifier, it will
become the Root Bridge. The user may choose a
time between 6 and 40 seconds. The default
value is 20.
hellotime <value 1-10> - The user may set the
time interval
configuration messages by the root device, thus
stating that the Switch is still functioning. A time
between 1 and 10 seconds may be chosen, with
a default setting of 2 seconds.
forwarddelay <value 4-30> - The maximum
amount of time (in seconds) that the root device
will wait before changing states. The user may
choose a time between 4 and 30 seconds. The
default is 15 seconds.
priority <value 1-65535> -
between 1 and 65535 to specify the priority of the
Switch. The lower the value, the higher the
priority. The default is 32768.
Figure 73. config stp command
between transmission
Select a value
of