D-Link DES-2108 User Manual page 118

Example Usage:
Figure 119. config radius 802.1x command
config 802.1x
Purpose
Syntax
Description
Parameters
112
Used to configure 802.1x on the switch.
[auth_configuration [enable_reauth <enable |
disable> | quiet_period <secs 0-65535> |
tx_period <secs 1-65535> | supp_timeout <secs
1-65535> | server_timeout <secs 1-65535> |
max_req <secs 1-10> | reauth_period <1>]
Port <port_list> <enable | disable>]
This command allows you configure 802.1x on
the switch.
quiet period <quiet_period> - Sets the number
of seconds that the switch remains in the quiet
state following a failed authentication exchange
with the client. Default 80 seconds
tx period <tx_period> - Sets the number of
seconds that the switch waits for a response to
an EAP-request/identity frame from the client
before retransmitting the request. Default is 24
seconds.
supp timeout <supp_timeout> - Sets the
switch-to-client retransmission time for the EAP-
request frame. Default is 12 seconds
server timeout <server_timeout> - Sets the
amount of time the switch waits for a response
from the client before resending the response to
the authentication server. Default is 16 seconds.
max req <max_req> - This parameter specifies
the maximum number of times that the switch
retransmits an EAP Request packet to the client