Using The Cli Via Telnet Interface - D-Link DES-2108 User Manual

Figure 41. SmartConsole Utility

Using the CLI via Telnet interface

To configure the Switch through the TCP/IP Telnet protocol, using an
ordinary telnet client program. On many systems to invoke a telnet
client is:
telnet ip-address
Where ip-address is the IP address you have assigned to the Switch.
When you telnet to the Switch, it displays its login-in message:
Figure 42. The DES-2108 console login
At this point you can enter the password you have assigned to your
Switch. The factory default password is "admin".
47