D-Link DES-2108 User Manual page 81

config stp ports
Purpose
Syntax
Description
Parameters
Example usage:
To configure STP with path cost 10, priority of 100 for ports 1-5:
show stp
Purpose
Syntax
75
Used to setup STP on the port level.
config stp ports [all | <portlist>] {cost <value
1-65535> | priority <value 0-255>}
This command is used to create and configure
STP for a group of ports.
[all | <portlist>] - Specifies all ports or range of
ports to be configured.
cost <value 1-65535> - This defines a metric
that indicates the relative cost of forwarding
packets to specified port list. The value between
1 and 65535 to determine the cost. The lower the
number, the greater the probability the port will
be chosen to forward packets. The default value
is 10.
priority <value 0-255> - Select a value between
0 and 254 to specify the priority for a specified
port for forwarding packets. The lower the value,
the higher the priority. The default is 128.
Figure 74. config stp ports command
Used to display the Switch's current STP
configuration.
show stp