config switch system_timeout
Purpose
Syntax
Description
Parameters
Example usage:
To set the timeout time:
Basic IP Commands
The basic IP commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
config ipif
show ipif
Each command is listed, in detail, in the following sections.
56
Specifies the maximum amount of time a host
can access the management interface. The
default is 5 minutes
config switch system_timeout <value 3~30
min>
The command is used to configure the maximum
amount of time a host can access the
management interface.
<value 3~30 min> - The timeout time for
management access. The value in minutes may
be between 3 and 30 seconds.
Figure 52. config switch system_timeout command
Parameters
[ipaddress <network address> {gw
<ipaddress>}
1~4094>}]
|
dhcp
{vid
<vid