1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
ACL
The ACL link allows you to configure the Access Control List for the switch. You can
configure ACL on the following three pages:
•
MAC Based ACL
•
IP Standard ACL
•
IP Extended ACL
MAC Based ACL
Clicking the M
AC
which displays the various parameters to configure the MAC Access List. The
parameters for this page are shown in
Table 5-10. MAC ACL Configuration Page Parameters
Parameter
ACL Number
Source and
Destination MAC
Figure 5-16. MAC ACL Configuration Page
ACL tab brings up the M
Description
This specifies the unique Id for the access list. Valid range is 1 to 65535. The
factory default is blank.
This specifies both the Source MAC Address and Destination MAC Address, for
which the access list must be applied. Both the Source and Destination MAC
Addresses must be configured for the status of the access list to be active. The
factory default is blank.
ACL C
AC
ONFIGURATION
Table
5-10.
5-26
page
(Figure
5-16),