Bgp Filter - Supermicro SSE-X3348T/R User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual

BGP Filter

Clicking the F
ILTERS
which is used to set the filters on the routes being learnt. The parameters for this page
are shown in Table
Table 5-104. BGP Filter Configuration Page Parameters
Parameter
Filter ID
Remote AS
IP Address
IP Address Prefix
Length
Intermediate AS
Direction
Action
Status
Figure 5-122. BGP Filter Configuration Page
tab brings up the BGP F
5-104.
Description
This parameter specifies the filter index.
This parameter specifies the remote AS associated with the BGP peer from
which the router is being distributed.
This parameter specifies the IP address for which the route is being learnt.
This parameter specifies the prefix length to calculate the Subnet.
This parameter represents the intermediate AS between the BGP peers.
This parameter indicates the direction of the packet.
With this parameter you can choose either to Allow (not to filter) or Deny (Filter)
for the above configuration set.
This parameter specifies the status of the entry.
C
ILTER ONFIGURATION
5-148
page (Figure 5-122),