Port Configuration - Supermicro SSE-X3348T/R User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual

Port Configuration

Clicking the P
ORT
which sets the configuration per Port related to MSTP. The parameters for this page are
shown in Table
Parameter
Port
Admin Status
Priority
Path Cost
Protocol Migration
Edge Status
Point-to-Point Status
Hello Time (Seconds) This parameter specifies the administrative value of Hello Time for the port.
Auto Edge Status
Figure 5-69. CIST Settings Page
C tab brings up the CIST S
ONFIGURATION
5-52.
Table 5-52. CIST Settings Page Parameters
Description
This parameter specifies the port identifier.
This parameter specifies the MSTP protocol status that can be enabled/disabled
on the particular port.
This parameter specifies the port priority used in role selection.
This parameter specifies the path cost associated with this port.
This parameter controls the migration among MSTP, RSTP and STP protocols, if
the other side of the switch runs a different mode. Migration takes place only if
this is enabled.
This parameter must be configured if the corresponding port is an edge port.
This parameter allows you to configure the ports explicitly as point-to-point
(Force true), as a non-point-to-point port, or leave the decision to be made
dynamically (from the AL or MAC layer).
If set to True, the edge port status will be dynamically calculated.
5-90
page (Figure
ETTINGS
5-69),