Stack Configuration; Stack Details; Stack Link Status - Supermicro SSE-X3348T/R User Manual

NOTE: In a stack only one switch can be configured as master. Otherwise the
slave switches will not allow you to configure anything except stacking disabled.
To login to slave switches, use a login name as "stackuser" and password as
"stack123".
Removing a stacked switch
To remove a switch from stacking follow the below recommended procedure:
1. Disconnect stacking cables.
2. Reboot the removed switch as a standalone switch.
3. Disable stacking.
4. Reboot the switch again to operate as regular stand-alone switch.
NOTE: When a switch is moved from stacking to stand-alone mode, the saved
stacking configurations can not be loaded in stand-alone mode. When stacking
is disabled, the switch software renames the existing configuration file to avoid
automatic restoration of stacking configurations on a stand-alone switch.
The following pages are available for configuring Stack settings;
•

Stack Configuration

•

Stack Details

•

Stack Link Status

• Stack Counters
Chapter 5: Web Based Management Utility
5-57