Rip6 Interface - Supermicro SSE-X3348T/R User Manual

RIP6 Interface

Clicking the RIP6 I
(Figure 5-104). The parameters for this page are shown in
Table 5-86. RIP6 Interface Configuration Page Parameters
Parameter
Interface ID
Status
Prof ID
Metric Offset
Def Rt Adv
Prof Horizon
Per-Updt Timer
Trig-Dly Time
Route Age Time
Garbage Timer
Figure 5-104. RIP6 Interface Configuration Page
tab brings up the RIP6 I
NTERFACE
Description
Specifies the Interface Id for which RIPv6 needs to be configured.
This parameter specifies the administration status of the interface.
This parameter indicates the Index of the Address Profile entry.
This parameter specifies the metric for the routes that are being re-distributed.
This parameter indicates the default router lifetime to be placed in the Router
Advertisements sent on the interface.
This parameter specifies the operational status of Profile Horizon in the system.
This parameter specifies the time interval between successive RIP6 updates.
This parameter indicates the time interval in seconds by which further triggered
updates are delayed, after one triggered update is sent.
This parameter specifies the time interval after which, the routes are flushed.
This parameter specifies the time interval after which, the invalid routes are
removed from the routing table.
Chapter 5: Web Based Management Utility
NTERFACE
5-127
C
ONFIGURATION
Table 5-86.
page