Bgp; Bgp Basic Settings; Bgp Peer Configuration; Bgp Med Configuration - Supermicro SSE-X3348T/R User Manual

Table 5-99. OSPF AS External Aggregation Configuration Page Parameters
Parameter
Aggregation Effect
Translation

BGP

The BGP link allows you to configure the BGP protocol. Following are the configuration
parameters available to manage BGP through this interface:
•

BGP Basic Settings

•

BGP Peer Configuration

•

BGP MED Configuration

• Local Preference
• BGP Filter
• Route Aggregations
• Advanced BGP Configuration
• BGP Community Management
Description
This parameter specifies the Aggreation option as one of the following:
• Advertise – When set to advertise and the associated Area ID is 0.0.0.0,
then aggregated Type-5 are generated. Otherwise if associated Area ID is
x.x.x.x (other than 0.0.0.0), then aggregated Type-7 is generated in NSSA
x.x.x.x for the specified range.
• Do Not Advertise – When set to doNotAdvertise (2) and the associated
Area ID is 0.0.0.0, then Type-5 is not generated for the specified range,
while aggregated Type-7 are generated in all attached NSSA. While
associated Area ID is x.x.x.x (other than 0.0.0.0), then Type-7 are not
generated in NSSA x.x.x.x for the specified range.
• Allow All – When set to allowAll and associated Area ID is 0.0.0.0, then
aggregated Type-5 are generated for the specified range. In addition
aggregated Type-7 are generated in all attached NSSA, for the specified
range.
• Deny All – When set to denyAll neither Type-5 nor Type-7 will be generated
for the specified range.
This parameter enables or disables the translation.
Chapter 5: Web Based Management Utility
5-143