Interface - Supermicro SSE-X3348T/R User Manual

Interface

Clicking the I
NTERFACE
(Figure 5-108). The parameters for this page are shown in
Table 5-90. OSPF Interface Configuration Page Parameters
Parameter
Interface
Area ID
Priority
Authentication Type
MD5 Key ID
Authentication Key
IP Address
Designated Router
Status
Figure 5-108. OSPF Interface Configuration Page
tab brings up the OSPF I
Description
This parameter specifies the interface index of the port.
This parameter indicates the 32-bit integer uniquely identifying the area to which
the interface connects.
This parameter specifies the priority of this interface, which is used in the DR
election algorithm.
This parameter allows you to choose MD5, Simple Password or None as the
authentication type.
This parameter specifies the secret key used to create the message digest
appended to the OSPF packet, if the authentication type is MD5.
This parameter specifies the key required for authentication, if authentication is
enabled on this interface.
This parameter specifies the IP Address of the OSPF interface.
This read-only field specifies the IP Address of the Designated Router.
When this parameter is enabled, the interface is advertised as an internal route
to some area. When disabled it denotes that the interface is external to OSPF.
Chapter 5: Web Based Management Utility
NTERFACE
5-131
C page
ONFIGURATION
Table 5-90.