Tacacs+ Server Configuration - Supermicro SSE-X3348T/R User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual

TACACS+ Server Configuration

Clicking the TACACS+ S
page (Figure 5-11), which allows you to configure TACACS servers. The parameters for
this page are shown in
Table 5-6. TACACS+ Server Configuration Page Parameters
Parameter
IP Address
Port
Single Connection
Timeout
Secret Key
Figure 5-11. TACACS+ Server Configuration Page
tab brings up the TACACS+ S
ERVERS
Table 5-6.
Description
This specifies the IP address of the TACACS server. The factory default is blank.
TCP port for TACACS protocol. The valid range is from
This specifies the
1 to 65000. The factory default is blank.
Specify Yes or No for a single TCP connection. If Yes, it establishes only a single
TCP connection with a given TACACS server. The factory default is Yes.
The time for which the switch will wait for a response from the TACACS server
before closing the connection is specified with this parameter. It is configurable in
seconds, with the valid range is from 4 to 15 and the default as 5-seconds..
This specifies the encryption key for the given TACACS server. It has a
32-character input limit, and the factory default is blank.
5-20
C
ERVER ONFIGURATION