Omron E5CN-HT User Manual page 66

Using Infrared Communications
44
3. Enabling Digital Controller Infrared Communications
Mount the Digital Controller to the panel and wire it. Turn ON the power
supply for the Digital Controller, go to the adjustment level, and set the In-
frared Communications Use parameter to ON. When this parameter is set
to ON, the Ir indicator on the front panel of the Digital Controller will light.
This enables connecting to a personal computer using infrared communi-
cations.
Lit when Infrared Communications
Use parameter is set to ON.
4. Connecting the USB-Infrared Conversion Cable to the Digital Controller
Mount the enclosed adapter to the Digital Controller. Hold the USB-Infra-
red Conversion Cable with the label side facing up, and insert the Cable
into the adapter to the line specified on the label.
E5EN-HT Series
Line on label
5. Setting the Setup Tool Communications Conditions
Set the communications port (COM port) number to be used for the CX-
Thermo Setup Tool to the COM port number assigned to the USB-Infrared
Conversion Cable.
Refer to the E58-CIFIR USB-Infrared Conversion Cable Instruction Sheet
E5EN-HT Series E5AN-HT Series
Mounting adapters
E5AN-HT Series
Section 2-4
Insert up to the line