Omron E5CN-HT User Manual page 150

Performing Manual Control
Manual MV Limit
Enable (manl)
Moving from the
Operation Level to the
Manual Control Level
Press O key for at least 1 s.
Manual Control Level
C
25.0
20.0
PV/MV
128
(2) For Manual MV Limit Enable, this value will be between the MV lower limit
and the MV upper limit.
(3) This setting is enabled only when the Direct Setting of Position Propor-
tional MV parameter is set to ON.
When the Manual MV Limit Enable parameter is set to ON (enabled), the MV
limits will function and the setting range for the Manual MV parameter will be
between the MV upper limit and the MV lower limit. When the parameter is set
to OFF (disabled), MV limits will not function.
Parameter name
Manual MV Limit OFF: Disabled, ON: Enabled
Enable
• When the O Key is pressed for at least 3 seconds in the operation level's
auto/manual switching display, the manual mode will be entered and the
manual control level will be displayed. It is not possible to move to any dis-
plays except for the PV/MV parameter during manual operation. Press the
O Key for at least one second from the PV/MV parameter display in man-
ual control level to return to automatic mode and display the top parame-
ter in the operation level.
Operation Level
a-m
Press O key for at least
3 s.
a-m display flashes for
at least 1 s.
• If an event input is set to MANU (auto/manual), the Auto/Manual Switch
parameter will not be displayed. Use the event input to switch between
automatic and manual modes.
Setting range
ON
C 25.0
PV
M
C 25.0
PV/SP
100.0
M
a-m
Auto/Manual Switch
M
prg
Program No.
0
M
Section 4-12
Default