Omron E5CN-HT User Manual page 303

Advanced Function Setting Level
See
See
p-db
PV Dead Band
Function
Setting
See
See
manl
Manual MV Limit Enable
Function
Setting
See
See
■ Related Parameters
PID set automatic selection range upper limit (PID setting level): Page 280
PID set number (program setting level): Page 201
• For position-proportional models, control is executed with the process
value equal to the set point when the process value is within the PV dead
band.
• This function prevents unnecessary outputs when the process value
approaches the set point.
Setting range
0.0 to 32400
■ Related Parameters
Closed/floating (initial setting level): Page 250
Motor calibration (initial setting level): Page 251
Travel time (initial setting level): Page 251
Position proportional dead band (adjustment level): Page 222
Open/close hysteresis (adjustment level): Page 222
This parameter sets whether the MV Upper Limit and MV Lower Limit param-
eters are to be enabled for manual MV in manual mode.
on: Enabled, off: Disabled
■ Related Parameters
PID * MV upper limit, PID * MV lower limit (PID setting level): Page 227
Position-proportional control must be
supported.
Unit
EU
The control must be set to 2-PID
control.
Close control (position-proportional
models) must be used.
Setting range
Section 5-10
Default
0.0
Default
OFF
281