Omron E5CN-HT User Manual page 261

Initial Setting Level
s-hc
Standard or Heating/Cooling
Function
Setting
See
See
cp
Control Period (Heating)
c-cp
Control Period (Cooling)
Function
• This parameter selects standard control or heating/cooling control.
• When heating/cooling control is selected for the E5CN-HT (for a model
which does not support control output 2), the auxiliary output 2 terminal
(SUB2) is assigned as the control output (cooling).
Note If you select standard control, set the Control Output 1 Assignment
parameter to o (heating control output) for either a direct (cooling)
or reverse (heating) application.
Setting range
stnd: Standard, h-c: Heating/cooling
■ Related Parameters
MV monitor (heating): Page 194, MV monitor (cooling): Page 194 (operation
level)
Cooling coefficient, Dead band: Page 217, Hysteresis (heating), Hysteresis
(cooling): Page 218 (adjustment level)
Control period (heat), Control period (cool) (initial setting level): Page 239
Control output 1 assignment: Page 273, Control output 2 assignment, Auxil-
iary output 1 assignment: Page 275, Auxiliary output 2 assignment: Page 276,
Auxiliary output 3 assignment: Page 277 (advanced function setting level)
• These parameters set the output periods. Set the control periods taking
the control characteristics and the electrical durability of the relay into
consideration.
• For standard control, use the Control Period (Heating) parameter. The
Control Period (Cooling) parameter cannot be used.
• When the heating control output is a current output or linear voltage out-
put, the Control Period (Heating) parameter cannot be used.
Section 5-9
Default
stnd
The cooling control output and heat-
ing control outputs must be assigned
to relay outputs, voltage outputs (for
driving SSR).
The control must be set to 2-PID
control.
For the Control Period (Cooling)
parameter, the control must be set to
heating/cooling control.
239