Omron E5CN-HT User Manual page 273

Initial Setting Level
calb
Motor Calibration
Function
See
See
mot
Travel Time
Function
Setting
See
See
sqr
Extraction of Square Root Enable
Function
Setting
See
See
• This parameter is used to calibrate a motor. It must be executed when
monitoring valve opening. (The display cannot be changed during motor
calibration.)
• The travel time is reset when motor calibration is executed.
• The setting becomes off after switching to this parameter.
• Motor calibration is executed when on is selected.
• The setting returns to off after the motor calibration has been completed.
■ Related Parameter
Travel Time (initial setting level): Page 251
• This parameter sets the time from when the valve is completely open until
it is completely closed.
• The travel time is set automatically when motor calibration is executed.
Setting range
1 to 999 s
■ Related Parameter
Motor Calibration (initial setting level): Page 251
This parameter enables and disables square root extraction.
Setting range
on: Enabled, off: Disabled
■ Related Parameter
Extraction of square root low-cut point (adjustment level): Page 223
Position-proportional control must be
supported and there must be a
potentiometer input.
Position-proportional control must be
supported.
Unit Default
30
An analog input must be supported.
Default
None
Section 5-9
251