Omron E5CN-HT User Manual page 297

Advanced Function Setting Level
sub1
Auxiliary Output 1 Assignment
Function
Setting
Note
See
See
• This parameter sets the function to be assigned to auxiliary output 1.
none: No function is assigned to auxiliary output 1.
o:
Heating control output is output.
c-o:
Cooling control output is output. (See note 1.)
alm1: Alarm 1 is output.
alm2: Alarm 2 is output.
alm3: Alarm 3 is output.
p.end: Program end is output.
ralm: Control output ON/OFF count alarm
stg:
Stage output
run:
Run output
ts1:
Time signal 1 output
ts2:
Time signal 2 output
wr1:
Work bit 1 (See note 2.)
wr2:
Work bit 2 (See note 2.)
wr3:
Work bit 3 (See note 2.)
wr4:
Work bit 4 (See note 2.)
wr5:
Work bit 5 (See note 2.)
wr6:
Work bit 6 (See note 2.)
wr7:
Work bit 7 (See note 2.)
wr8:
Work bit 8 (See note 2.)
(1) If c-o is assigned for standard control, a value equivalent to 0% will be
output.
(2) WR1 to WR8 are not displayed when the logic operation function is not
used.
■ Related Parameters
Standard or heating/cooling: Page 239 (initial setting level)
Auxiliary output 1 must be assigned.
Setting range
Section 5-10
Default
alm1
(See note
3.)
275