Omron E5CN-HT User Manual page 372

is disabled, the SP mode is initialized to RSP. If the Reset Operation parameter is changed from
stopping control to fixed SP operation and the SP mode is PSP, it will be initialized to FSP.
(12) The default values are as follows:
Temperature Input
Depends on the setting of the PID Set Automatic Selection Data parameter and the upper and lower
limits for the input setting range (which depends on the temperature unit).
• PID Set Automatic Selection Data = PV: Upper limit + 20 C (40 F)
• PID Set Automatic Selection Data = DV: Upper limit
• PID Set Automatic Selection Data = SP: Upper limit
Analog Input
The default is 105.0 (regardless of the setting of the PID Set Automatic Selection Data parameter.
(13) Initialized when the input type is changed from a temperature input to an analog input or from an
analog input to a temperature input.
(14) Initialized to 233 if the integral time is 0 and the Close/Floating parameter is set for floating control.
(15) Initialized to 0.8 when the temperature unit is C, and to 1.4 when the temperature unit is F.
(16) Initialized to the remote SP lower limit.
(17) Initialized only when the PID ON/OFF parameter is set to ON/OFF control.
(18) The Operation End Operation parameter is initialized when the Reset Operation parameter is set to
fixed SP operation.
(19) Initialized only when the standby time unit is set to days and hours.
350
Lower Limit + 20 C (40 F)
Appendix