Omron E5CN-HT User Manual page 223

Program Setting Level
Setting
Note
See
See
pid
PID Set No.
Function
Setting
See
See
al-1
Alarm Value 1
al-2
Alarm Value 2
al-3
Alarm Value 3
These parameters are set to one of the input values (X) in the alarm type list.
Function
Setting range
0.00 to 99.59 Hours and minutes, or minutes and seconds
The unit is set in the Program Time Unit parameter. (The default is H-M (hours
and minutes).)
■ Related Information
4-15 Program-related Functions: Page 138
■ Related Parameters
Step time/rate of rise programming (initial setting level): Page 252
Segment n type (program setting level): Page 199
This parameter sets the PID set number for the specified program number.
If this parameter is set to 0, the automatic PID set selection function will auto-
matically select the PID set number to be used in control according to the PV,
DV, and SP.
Setting range
0 to 8 1
■ Related Information
4-14 Using PID Sets: Page 136
These parameters set the alarm value for alarms 1 to 3 of the specified pro-
gram number.
For a temperature input, the decimal point is automatically set according to
the selected sensor. For an analog input, the decimal point is set according to
Decimal Point parameter setting.
Unit
Control must be set to 2-PID control.
Default
Alarms 1 to 3 must be assigned.
The alarm 1 to 3 type must not be set
to 0, 1, 4, 5, or 12.
Section 5-4
Default
0.00
201