Chery Tiggo 2009 Service Manual page 1556

• Disconnect the airbag special load tool.
• Disconnect the RCM connector (1) (See Restraints
Control Module (RCM) Removal & Installation in
Section 14 Restraints).
NOTE :
Check connectors - Clean and repair as necessary.
• Check the harness for continuity of the passenger
airbag circuit between terminal 13 in the RCM elec-
trical connector J-001 terminal side and terminal 1
in the passenger airbag electrical connector J-002
terminal side.
• Continuity should exist.
FRONT
PASSENGER RCM
AIRBAG TERMINAL
TERMINAL
1 13
• Check the harness for continuity of the passenger airbag circuit between terminal 14 in the RCM electrical con-
nector J-001 terminal side and terminal 2 in the passenger airbag electrical connector J-002 terminal side.
• Continuity should exist.
FRONT
PASSENGER RCM
AIRBAG TERMINAL
TERMINAL
2 14
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the spiral cable.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
CHECK CONTINUITY
CONTINUITY
Yes
CHECK CONTINUITY
CONTINUITY
Yes
LTSM140006
14
27
14–