Bleeding Hydraulic Clutch Operation - Chery Tiggo 2009 Service Manual

Bleeding Hydraulic Clutch
Operation
1. Verify fluid level in brake master cylinder. Top off
with DOT 4 brake fluid as necessary. Leave cap
off.
2. Raise the vehicle on hoist.
3. Remove the bleed port protective cap and install a suitable size and length of clear hose to monitor and divert
fluid into a suitable container.
4. Loosen the bleed port (1).
5. Actuate the clutch pedal until the brake master cylinder fluid drains from the bleed port.
6. Depress the clutch pedal, tighten the bleed port.
7. From driver's seat, actuate the clutch pedal until the hydraulic clutch system has pressure.
8. Depress the clutch pedal, loosen the bleed port and bleed the brake master cylinder fluid.
9. Repeat steps 6 to 8 several times until there is no air in the hydraulic clutch system.
NOTE :
Do not allow clutch master cylinder to run dry while fluid exits bleed port.
10. Close the hydraulic bleed port, remove the drain hose and replace the dust cap on the bleed port.
11. Top off the brake master cylinder fluid level with DOT 4 brake fluid as necessary.
CAUTION:
During the bleeding process, make sure the brake master cylinder fluid is always full.
Chery Automobile Co., Ltd.
CLUTCH ASSEMBLY SERVICE
LTSM080195
08
LTSM020210
325
08–