Check 2Nd Gear Solenoid Power Supply; Check 2Nd Gear Solenoid Control Circuit - Chery Tiggo 2009 Service Manual

4.

CHECK 2ND GEAR SOLENOID POWER SUPPLY

• Turn ignition switch on.
• Check 2nd gear solenoid power supply between
E-086 terminal 9 and ground in the A/T assembly
connector E-086.
• Voltage should be more than 12 V.
Is the check result normal?
Yes >>
Go to step 6.
No >>
Go to the next step.
5.
DETECT MALFUNCTIONING PART
• Check the following:
− Harness connectors A-102, E-105.
− Body fuse and relay box H9, H8, G15.
− Fuse 10 (30A).
− Harness for an open or short between A/T assembly connector and fuse.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Repair or replace the open circuit or short to ground or short to power in harness or connectors.
6.

CHECK 2ND GEAR SOLENOID CONTROL CIRCUIT

• Turn ignition switch off.
• Disconnect TCM connector.
• Check for harness continuity between the following terminals:
A/T ASSEMBLY
CONNECTOR
TERMINAL
TERMINAL
4
• Check the harness for short to power and short to ground.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Repair or replace the open circuit or short to power or short to ground.
192
08–
DIAGNOSIS & TESTING
TCM
CONTINUITY
16 Yes
Chery Automobile Co., Ltd.
LTSMD080012