Steering Gear On-Vehicle Service; Steering Gear - Lhd Removal & Installation - Chery Tiggo 2009 Service Manual

Steering Gear - LHD
Removal & Installation
1 - Steering Gear Inlet/Outlet Pipe
2 - Dust Boot
3 - Steering Gear Lock Nut
NOTE :
The following special tools are required to perform the repair procedure:
• CH-10002 - Ball Joint Separator
1. Siphon out as much power steering fluid as possible from the reservoir.
WARNING!
Prolonged and repeated contact with power steering fluid will damage skin. If steering fluid is spilled on your
skin, wash it off immediately with water.
2. Remove the wheel mounting nuts and wheel assemblies from both sides of the vehicle.
(Tighten: Wheel mounting nuts to 110 N·m)
3. Remove the return hose clamp (1) from the steer-
ing liquid reservoir and insert the end of the hose
into a container.
4. Start the engine and turn the steering wheel from lock-to-lock until all power steering fluid has been drained from
the system.
5. Stop the engine.
6. Raise and support the vehicle.
Chery Automobile Co., Ltd.
ON-VEHICLE SERVICE
4 - Steering Gear Retaining Hole
5 - Clamp
6 - Tie Rod Lock Nut
LTSM110036
11
LTSM110042
21
11–