Rear Suspension On-Vehicle Service; Rear Lower Control Arm Removal & Installation - Chery Tiggo 2009 Service Manual

Rear Lower Control Arm
Removal & Installation
1. Raise and support the vehicle.
2. Remove the bolt that joins rear stabilizer bar and rear suspension lower control arm (See Rear Stabilizer Bar
Link Removal & Installation in Section 10 Suspension).
3. Remove the retaining bolt (1) connecting the lower
control arm and rear trailing arm.
(Tighten: Lower control arm to rear trailing arm bolt
to 80 - 100 N·m)
4. Remove the retaining bolt (1) connecting the upper
control arm and rear sub-frame assembly.
(Tighten: Upper control arm and rear sub-frame
assembly bolt to 80 - 100 N·m)
5. Installation is in the reverse order of removal.
Installation Notes:
• After installation, each bolt must be tightened to the
required tightening torque.
30
10–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM100061
LTSM100066