Hood Removal & Installation; Hood Adjustment - Chery Tiggo 2009 Service Manual

Hood
Removal & Installation
1. Remove the hood mounting bolts (1) and the stay
bars (2).
(Tighten: Hood mounting bolts to 23 ± 2 N·m)
N·m)
2. Loosen the windshield washer hose.
3. Remove the hood.
4. Installation is in the reverse order of removal.

Hood Adjustment

1. Adjust the hood gap with a spacer gauge.
• The gap between the hood and the fender should be 5 ± 0.5 mm
• The overall levelness when measured with a magnet should be 0-0.5 mm
2. Install the nuts (Part Number: Q1400820, 2 pcs both upper and lower) into the body for 2-3 turns, tighten with
pneumatic wrench. Torque: 30 ± 4 N·m.
Check for the following after repair:
• Whether the bolts and nuts are assembled properly
• Whether the bolts and nuts are properly tightened
• Whether the gap between the hood and the fender are within specifications
• Whether the horizontal alignment of the front edge of the fenders is within specifications (0-0.5 mm)
202
15–
HOOD
Chery Automobile Co., Ltd.
LTSM150107