Back Cargo Door Removal & Installation; Replacing Rear Door Hinge; Back Cargo Door Disassembly - Chery Tiggo 2009 Service Manual

Replacing Rear Door Hinge

1. Remove the door check bolts.
2. Support the door.
3. Remove the four retaining bolts from the upper and lower hinges, and then remove the hinges.
Back Cargo Door
Removal & Installation
1. Remove the two back cargo door bolts connecting the back door and hinge.
(Tighten: Bolts connecting the back door and hinge to 50 ± 5 N·m)
(Tighten: Bolts connecting the hinge and body to 36 ± 4 N·m)
2. Disconnect the wiring harness electrical connector.
3. Remove the two mounting bolts (1) of the back
cargo door stopper on body.
(Tighten: Bolts connecting the back cargo door
stopper bracket and body to 27 N·m)
4. Remove the back cargo door.
5. Installation is in the reverse order of removal.
Disassembly
1. Remove the back cargo door panel.
2. Remove the rear wiper motor (See Rear Wiper
Motor Removal & Installation in Section 15 Body &
Accessories).
3. Remove the protective film from the back cargo
door.
4. Remove mounting bolts, pull out the harness.
5. Remove the outside handle mounting bolts (1) from
one side of the door panel.
Chery Automobile Co., Ltd.
DOORS
LTSM150113
15
LTSM150121
175
15–